![]() Enter the address to which you'd like to send STX, the amount of STX and an optional memo describing the transfer.Select "Send" at the top of the window under your total balance.Copy the address shown in the Hiro Wallet to receive STX from it.Verify that the address shown in the Hiro Wallet matches the one shown on your Ledger device and select "Approve".Select "Receive" at the top of the window under your total balance.Select "Approve" on your Ledger device to proceed with using the Hiro Wallet.Your total balance is shown at the top of the window under "Total balance".Select "Continue" to view the receive address on your Ledger device.Open the Stacks app on your Ledger device.Connect your Ledger and enter its PIN on the device.You'll need to transfer your recovery phrase to a separate Nano S or X device. Ledger Blue is not supported by the Hiro Wallet.Press both top buttons on your Ledger device simultaneously to proceed whenever it shows "Pending Ledger review" on the screen.If you don't see the upgrade option, turn off "Developer Mode" before proceeding. Don't turn on "Developer Mode" before upgrading your firmware, otherwise Ledger Live won't show you the dialog to upgrade.Return to Hiro Wallet and proceed with authentication.Confirm "Allow Ledger manager" on device.Connect and enter your PIN on your Ledger device.Go to "Manager" on the left-hand side of Ledger Live.Select "Settings" in the top-right corner of Ledger Live then the "Experimental features" tab.Upgrade your firmware for Ledger Nano S to version 1.6.1 or Nano X to version 1.2.4-5 or greater.You'll need to install it there before proceeding to connect your Ledger Nano S or X device to the Hiro Wallet for authentication. The Stacks app is available in Ledger Live. The Stacks app for Ledger empowers users to connect their Ledger devices to the Hiro Wallet (MacOS, Windows and Linux) for securely managing their STX holdings and participating in Stacking. Once you've authenticated into the Hiro Wallet with either your Secret Key or hardware device, you'll see an option on the right-hand side of the home screen to "Get started" with Stacking: If you've decided to Stack directly through the Hiro Wallet, see the steps for participation below. After your chosen Stacking duration, you’ll have to wait one cycle before you can stack from the same address again, regardless of how many cycles you stacked The amount of STX required to participate has been steadily increasing since Stacking was initiated on mainnet.Ģ) Stacking is irreversible and once STX tokens are locked, they will not unlock even if the dynamic minimum increases and the STX are no longer eligible for rewards.ģ) There is a "cool down" cycle between Stacking cycles. Stacking is otherwise available through one of our partners at /stacking.Ī few things to note when Stacking directly: 1) Stacking directly requires meeting a dynamic minimum threshold of STX that changes based on participation. To participate in Stacking directly via the Hiro Wallet, you'll need at least the minimum number of STX in your Hiro Wallet balance.
0 Comments
Leave a Reply. |